TPU DP Dispensing Peristaltic Pump
Peristaltic pump designed to move liquids of low to high viscosity from source to destination at user-set speeds from 0 to 60 RPM. The easily accessible controls provide for Priming, dynamic Braking, setting RPM, and Reversing Flow direction. There is also a Power LED.The DP model has the added benefit of a programmable timer.
The timing device permits dispensing over a selected period of time as either a single volume of liquid dispensed every time the pump is activated according to the user’s settings, or via remote input through the “D” connector at the rear of the pump. Seven time periods are possible: 0.1 – 1 sec., 1 – 10 sec., 6 – 60 sec., 1 – 10 min., 6 – 60 min., 1 – 10 hr., or 10 – 100 hr.
Principle of Operation
Flexible tubing, which conveys fluid from source to destination, is squeezed inside the pump head by rotating rollers against a rigid, crescent-shaped occlusion wall. The rollers induce suction in a gently pulsing rhythm. The occlusion is adjustable to increase pressure, or to decrease pressure for extended tubing life.
Each pump comprises a front panel with controls, a pump head with adjustable occlusion wall, a safety cover, a motor, a rigid case with four rubber feet, and a handle. The handle is practical both to carry the pump and, when rotated beneath the pump, to serve as a base that lifts and angles the pump face, making the controls even more easily user-accessible.
| SPECIFICATIONS |
| TUBING INSIDE DIAMETERS: 1/4, 5/16, 3/8, 7/16 or 1/2 in. |
| TUBING WALL THICKNESS: 1/16 in. |
| RECOMMENDED TUBING MATERIALS: Tygon® E-3603, peroxide-treated silicone, platinum-treated silicone, PharMed®, Versilic® silicone, Tygon® Sanitary silicone, Norprene®, Tygon® Long Flex Life, and Hypalon® |
| PUMPING SPEED: adjustable from 0 to 60 RPM |
| FUSES: Two 2-Amp, 250 V, fast-acting, glass, 5 x 20 mm, UL-listed |
| POWER SUPPLY: power cord & plug appropriate to user’s country |
| ELECTRICAL REQUIREMENT: 90 - 264 VAC |
| MAXIMUM LIFT, PUMP HEAD: 340 in. H2O (12.3 psig) |
| MAXIMUM SUCTION, PUMP HEAD: 350 in. H2O (12.6 psig) |
| DIMENSIONS: 6.50 in. (165 mm) wide x 4.12 in. (105 mm) high x 6.40 in. (163 mm) deep (excluding handle) |
| MATERIALS OF CONSTRUCTION: anodized aluminum, 316 stainless steel rollers and shafts |
PUMP FLOW RATES
TPU Pump Flow Rates with 4 Rollers
TPU Pump Flow Rates with 10 Rollers
(NOTE: the use of 5/16 in. tubing is not recommended with this option)
Pumpen Prospekt Der komplette Katalog für Pumpen
Peristaltic Pumps and Pump Heads Operating Manual [EN] Peristaltic Pumps and Pump Heads Operating Manual - Rev. F, Feb-2019
Rotameter Prospekt Der komplette Katalog für Rotameter und Ventile
Massendurchflußmesser Prospekt Der komplette Katalog für Massendurchflußmesser und elektronische Ventile
